Plastic Spray Bottles

• Wipe bottles as necessary to avoid residue and buildup
• Replace label when needed
• Periodically take apart trigger and clean to avoid clogging

• Wipe down inside and out as needed

• Do not leave lying around - they are a disease and safety hazard. Keep in a bag for dirty rags
• Discard greasy or oily rags

• Disinfect and wipe front edge as needed

• Rinse in clear, cold water, shake out excess. If brush is dirty, wash it out in lukewarm cleaning solution and rinse with clear water. Let dry with bristles straight.
• Storage - hang brush - do not put the brush weight on the bristles.

• Do not use when wet, do not stand on its straws. Do not use broom for scrubbing. Rotate frequently so it will wear evenly.

• After each days use, wipe knife to remove moisture and debris.
• Store in clean, dry place.
• Edge the blade as needed to keep it sharp

• Rinse with water immediately after use.

• Do not use dry mops to pick up liquids. Do not use dust mops on oily floors.
• Remove loose soil frequently, using a vacuum cleaner if possible; otherwise shake into large waste receptacle.
• Never store a mop on the floor. Hang the mop so air can circulate.

• Before using a new mop, soak for several minutes to remove sizing and toughen the fibers.
• Rinse after use.
• Do not twist the mop in the wringer. If it is twisted or squeezed too hard it can be destroyed because the actions will break the fibers.
• Use your fingers to straighten the strands.
• Cut off loose or uneven strands.
• Hang mops to dry in a light, airy place. Never store on the floor or in the mop bucket.

• After using, wash out all floor finish or wax with clean water.
• Wring out as much water as possible, shake to fluff strands.
• Never use detergent or soap on a mop intended for floor finish.
• Put mop in a clean plastic bag after use.

• Do not use force on a wringer lever - use only enough hand pressure on the lever to wring out the mop.
• Remove any loose mop head yarn, string or foreign matter that becomes tangled in the wringer.
• Wash and scrub all surfaces of the bucket with disinfectant. Rinse with warm water and wipe dry. Keep wringer oiled and tight.
• Keep wringer in "release" position when it is not being used.
• Rinse blade in clean water after use.
• Wipe dry, do not store with blade down or bent.

• Empty bag regularly.
• Wipe outside of vacuum after emptying.
• Check for strings, carpet yarns, etc. wrapped around beater bar.
• Check belt for cuts and change when needed.
• Empty magnet bar after each use.

• Wipe down entire surface after each day's use. Also wipe cord.
• Check pad for replacement.
• Blow out motor approximately every 2 weeks.
• Once per month check screws and bolts to ensure they are tight.

• Wipe down entire surface after each day's use. Also wipe cord.
• Rinse tank after each use.
• Check drive unit for cracks on wear.

• Floor pads can be used on both sides. Once both sides have been used, the pad should be set aside for cleaning or soaking.
• Floor pads can be cleaned by rubbing one against the surface of another. Or you can
  ISO 9000 Production
  Many industries and governments depend on ISO 9000 production standards these days. ISO 9000 production standards guarantee that all products are of a consistently high quality.Although the ISO production standards are still voluntary, lots of companies are using them as a standard when targeting foreign markets which require environmentally-safe products. The ISO 9000 production departments assure the quality of all equipment shipped.ISO 9000 production standards basically have three requirements. First, the business should document the quality system and business process in detail. Second, the business should make sure that each employee understands and follows the guideli
  Dust Pans
  • Disinfect and wipe front edge as needed
  Brushes
  • Rinse in clear, cold water, shake out excess. If brush is dirty, wash it out in lukewarm cleaning solution and rinse with clear water. Let dry with bristles straight.
  • Storage - hang brush - do not put the brush weight on the bristles.
  Brooms
  • Do not use when wet, do not stand on its straws. Do not use broom for scrubbing. Rotate frequently so it will wear evenly.
  Putty Knife
  • After each days use, wipe knife to remove moisture and debris.
  • Store in clean, dry place.
  • Edge the blade as needed to keep it sharp
  Measuring Cups
  • Rinse with water immediately after use.
  Dust Mops
  • Do not use dry mops to pick up liquids. Do not use dust mops on oily floors.
  • Remove loose soil frequently, using a vacuum cleaner if possible; otherwise shake into large waste receptacle.
  • Never store a mop on the floor. Hang the mop so air can circulate.
  Wet Mops
  • Before using a new mop, soak for several minutes to remove sizing and toughen the fibers.
  • Rinse after use.
  • Do not twist the mop in the wringer. If it is twisted or squeezed too hard it can be destroyed because the actions will break the fibers.
  • Use your fingers to straighten the strands.
  • Cut off loose or uneven strands.
  • Hang mops to dry in a light, airy place. Never store on the floor or in the mop bucket.
  Floor Finish Mops
  • After using, wash out all floor finish or wax with clean water.
  • Wring out as much water as possible, shake to fluff strands.
  • Never use detergent or soap on a mop intended for floor finish.
  • Put mop in a clean plastic bag after use.
  Buckets & Wringers
  • Do not use force on a wringer lever - use only enough hand pressure on the lever to wring out the mop.
  • Remove any loose mop head yarn, string or foreign matter that becomes tangled in the wringer.
  • Wash and scrub all surfaces of the bucket with disinfectant. Rinse with warm water and wipe dry. Keep wringer oiled and tight.
  • Keep wringer in "release" position when it is not being used.
  • Rinse blade in clean water after use.
  • Wipe dry, do not store with blade down or bent.
  Upright Vacuum Cleaners
  • Empty bag regularly.
  • Wipe outside of vacuum after emptying.
  • Check for strings, carpet yarns, etc. wrapped around beater bar.
  • Check belt for cuts and change when needed.
  • Empty magnet bar after each use.
  Buffers
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Check pad for replacement.
  • Blow out motor approximately every 2 weeks.
  • Once per month check screws and bolts to ensure they are tight.
  Slow Speeds
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Rinse tank after each use.
  • Check drive unit for cracks on wear.
  Synthetic Floor Pads
  • Floor pads can be used on both sides. Once both sides have been used, the pad should be set aside for cleaning or soaking.
  • Floor pads can be cleaned by rubbing one against the surface of another. Or you can
    Investing Stock Market ABC's
    While most folks today trust mutual funds and their professional managers with their investments, it’s still important to understand the basics of the stock market. Although investing in individual stocks may not be right for everyone, a basic understanding of the stock market is essential to understanding the workings of our economy and business sector.A stock is a portion of ownership in a company. Commonly referred to as a share, it is a small percentage of the total ownership pool for the corporation. Shareholders are stock owners, or people who have an ownership interest in the corporation. Today, shares are usually tracked electronically, but in previous decades sharehold
    Do not use dust mops on oily floors.
  • Remove loose soil frequently, using a vacuum cleaner if possible; otherwise shake into large waste receptacle.
  • Never store a mop on the floor. Hang the mop so air can circulate.
  Wet Mops
  • Before using a new mop, soak for several minutes to remove sizing and toughen the fibers.
  • Rinse after use.
  • Do not twist the mop in the wringer. If it is twisted or squeezed too hard it can be destroyed because the actions will break the fibers.
  • Use your fingers to straighten the strands.
  • Cut off loose or uneven strands.
  • Hang mops to dry in a light, airy place. Never store on the floor or in the mop bucket.
  Floor Finish Mops
  • After using, wash out all floor finish or wax with clean water.
  • Wring out as much water as possible, shake to fluff strands.
  • Never use detergent or soap on a mop intended for floor finish.
  • Put mop in a clean plastic bag after use.
  Buckets & Wringers
  • Do not use force on a wringer lever - use only enough hand pressure on the lever to wring out the mop.
  • Remove any loose mop head yarn, string or foreign matter that becomes tangled in the wringer.
  • Wash and scrub all surfaces of the bucket with disinfectant. Rinse with warm water and wipe dry. Keep wringer oiled and tight.
  • Keep wringer in "release" position when it is not being used.
  • Rinse blade in clean water after use.
  • Wipe dry, do not store with blade down or bent.
  Upright Vacuum Cleaners
  • Empty bag regularly.
  • Wipe outside of vacuum after emptying.
  • Check for strings, carpet yarns, etc. wrapped around beater bar.
  • Check belt for cuts and change when needed.
  • Empty magnet bar after each use.
  Buffers
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Check pad for replacement.
  • Blow out motor approximately every 2 weeks.
  • Once per month check screws and bolts to ensure they are tight.
  Slow Speeds
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Rinse tank after each use.
  • Check drive unit for cracks on wear.
  Synthetic Floor Pads
  • Floor pads can be used on both sides. Once both sides have been used, the pad should be set aside for cleaning or soaking.
  • Floor pads can be cleaned by rubbing one against the surface of another. Or you can
    Blackberry 8100 Pearl - The Smallest, Smartest Smartphone Yet
    The new Blackberry 8100 Pearl cell phone is one of the smallest, sleekest cell phones ever made. It is a small phone with clean, slick look and being one of the smallest smartphones every made it still has all of the features of a blackberry.Some of the features of the Blackberry 8100 Pearl are: a 1.3 mega pixel camera to capture your Kodak moments, a MP3 player that lets you listen to your favorite songs, expandable memory, etc. It of course comes with the regular features of a blackberry smartphone which is phone, email, web browser, text messaging (SMS and MMS), organizer to organize your applications, instant messaging, etc. It also gives you the capability to store 500 cel
    ssible, shake to fluff strands.
  • Never use detergent or soap on a mop intended for floor finish.
  • Put mop in a clean plastic bag after use.
  Buckets & Wringers
  • Do not use force on a wringer lever - use only enough hand pressure on the lever to wring out the mop.
  • Remove any loose mop head yarn, string or foreign matter that becomes tangled in the wringer.
  • Wash and scrub all surfaces of the bucket with disinfectant. Rinse with warm water and wipe dry. Keep wringer oiled and tight.
  • Keep wringer in "release" position when it is not being used.
  • Rinse blade in clean water after use.
  • Wipe dry, do not store with blade down or bent.
  Upright Vacuum Cleaners
  • Empty bag regularly.
  • Wipe outside of vacuum after emptying.
  • Check for strings, carpet yarns, etc. wrapped around beater bar.
  • Check belt for cuts and change when needed.
  • Empty magnet bar after each use.
  Buffers
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Check pad for replacement.
  • Blow out motor approximately every 2 weeks.
  • Once per month check screws and bolts to ensure they are tight.
  Slow Speeds
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Rinse tank after each use.
  • Check drive unit for cracks on wear.
  Synthetic Floor Pads
  • Floor pads can be used on both sides. Once both sides have been used, the pad should be set aside for cleaning or soaking.
  • Floor pads can be cleaned by rubbing one against the surface of another. Or you can
    Functions Of Bench Scales
    Weighing scale has come up with different types of scale products to the users and business people. Bench scales is also one of the commonly and highly used weighing scales by the customers. As per the customer requirement and satisfaction, bench scales are framed and offered to the customer. Nowadays, bench scales are used by more number of customers for their commercial and residential purpose. Bench scales also referred has platform scales and it measures the weight of the object accurately and correctly. Bench scale has come up with more and different varieties of products in different models, sizes, capacities and prices as per the needs of the customers. Bench scale has unique featu
    or strings, carpet yarns, etc. wrapped around beater bar.
  • Check belt for cuts and change when needed.
  • Empty magnet bar after each use.
  Buffers
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Check pad for replacement.
  • Blow out motor approximately every 2 weeks.
  • Once per month check screws and bolts to ensure they are tight.
  Slow Speeds
  • Wipe down entire surface after each day's use. Also wipe cord.
  • Rinse tank after each use.
  • Check drive unit for cracks on wear.
  Synthetic Floor Pads
  • Floor pads can be used on both sides. Once both sides have been used, the pad should be set aside for cleaning or soaking.
  • Floor pads can be cleaned by rubbing one against the surface of another. Or you can use a hand scratcher. Follow by rinsing with a sharp stream of hot water and giving a final rinse of cold water. Pads that do not respond to this method should be soaked overnight in a concentration of synthetic detergent or stripping solution. After soaking, each pad should be rinsed under a sharp stream of hot water. After a final rinse of cold water, the pads should be shaken and placed on a flat, non-rusting surface for drying. Pads are not ready for re-use until they are completely dry.
  • Tip: When pads become excessively worn, they can be cut into small sections that can be used as hand or foot scratch pads.
  Wet/Dry Vacs
  • Rinse out inside, wipe inside and out after each use.
  • Rinse and wipe hoses and attachments.
  Carpet Machines
  • Rinse out inside of tank, filters, hoses and attachments.
  • Wipe down outside.
  Pump-Up Sprayers
  • Release pressure.
  • Wipe outside.
  • When empty, rinse out, spray water through sprayer to keep from getting plugged up.